JJ CCR diluent miflex hose length

[Alastair]

Hi All,

I am trying to return a diluent reg back to CE format. Can anyone tell me the standard hose lengths? I.e length to 3 way, length of adv feed, length of wing feed, length of BOV feed etc. I realise the BOV isn't CE but my unit has one so I need it to be fed.

Thanks in advance
Al

 

[alexasigno]

There's a post by Rob (tecdiver) in the JJ forum which has all the hose lengths.

 

[Clare]

Do you mean the JJ forum on here (can't find it) or elsewhere.

 

[alexasigno]

Yeah I was sure it was on here. I've had a quick look and can't find it either.

 

[JoelSim]

Content copied from an earlier NickB post.... Not sure if it'll help or not!?

"Yes, all standard sizes. I do have a manifold on the O2 side, but these are the sizes I use:

O2 side
1 * 23cm - Reg to manifold
2 * 37cm - Manifold to Solenoid & MAV to T-piece
1 * 56cm - Manifold to MAV

Dil side
1 * 23cm - Reg to manifold
1 * 37cm - Manifold to ADV
1 * 71cm - Manifold to BOV
1 * 60cm inflator hose - Manifold to wing inflate

You also need something between the end of the ADV hose and the banjo fitting, as the ADV T-piece on the older units won't allow the hex fitting to turn. I use an Omniswivel locking QD, but an AP flowstop works well.


I paid around that in Sterling from my LDS, but the JJ price will need VAT & Shipping added too."

 

[Clare]

Thanks guys.

 

[nickb]

1 * 71cm - Manifold to BOV

FWIW, unless the cylinders are raised quite high, I find this length to be a little too short when turning my head to the right. Not too bad, but an extra few cm would be good.