CCR Liberty getting more versatile - BMCLs

lof

lof

Member
Testing new prototype STA for the CCR Liberty
It enables setup with any wing backplate configuration, BMCLs, TOS CLs or standard OTSCLs.

Here is configuration with Backmounted Counterlungs. More streamlined, compact and lightweight setup.

LibertyBMCL2.jpgLibertyBMCL1.jpg
 
How about a lower frame extension in order to assist in putting the RB on, while sitting on a boat bench? Ether your butt is on the bench or the rebreather is on the bench and your butt is hanging 5-6" lower than the bench.
I've solved the problem with my SF2, but most other rebreathers are still a problem.
If you make the extension out of Aluminum or Titanium that would do a lot to keep the trim from being screwed up.

Michael
 
That is already available on the stock unit, so it is part of the trimmed unit.
It is actually very clever stand that is balanced with or without bottles, with or without loop attached.
You can even fit a light canister in it and I clip my bailout bottles to the side openings.


CCR-Liberty-back-view.jpg
 
the lid design looks too fragile for a wreck ferret. I'd trash the connectors in no time flat. at the very least it looks like the top edge of the lid could do with radiusing to prevent the edge damaging the cables if they are trapped and prevent chips being taken out of the lid edge
 
There is already protecting gizmo for the lid in the works.
But the lid is pretty robust as it is., doubt you could do too much damage to it or the connectors.
 
You must log in or register to reply here.
Back
Top